This is a torch cut center section (approx 12”) of a BREN Mk2 Receiver.
These center sections were imported with alternative approved demilling spec.
The critical relationships between the locking shoulder, barrel nut, magazine housing, feed ramp, ejector, and barrel have been maintained. This is an ideal piece to start or save a difficult BREN semi auto project or repairing an old re-welded BREN.
The rear 5” of receiver has been cut away. There is approximately 1/4” of material behind the locking shoulder. The locking shoulder is present and looks to be in good condition.
The front 8” of the receiver has also been cut away.