Newly made item copied original
Black Oxide Finish
One Pin Included
This pin retains the pressure pawl and the retaining pawl in the MG34 feed block. Two pins are required for the feed block: 1 each for the front and rear pressure and retaining pawls.
One end of the pin is solid and the other countersunk. The solid end is inserted first leaving the countersunk end exposed at the rear for peening.
Over the years we've lost or bent a lot of these pins while working or MG34 Feed Blocks. We've also seen a lot of worn and rusted ones. With damaged pins the retaining and pressure pawls don't pivot properly and can lead to unreliable feeding.