Reference Drawings (PDF)
Weapons Guild Step by Step Build with BRP Receiver
WW2 Waffenmeister Handbook
MG42 SA Firing Pin Timing
Includes: Left & Right Stampings, Buffer Tabs, Ratchet Plate, and Rivets
The overall length on this is 406mm (approximately 25 mm longer than the previous version). They are just longer than the last ones we made to give people more...
Includes: Left & Right Stampings, Buffer Tabs, and Rivets
The overall length on this is 406mm (approximately 25 mm longer than the previous version). They are just longer than the last ones we made to give people more material in the...
MG-42 Assembled Barrel Shroud Stampings with Front Bushing Installed
OAL 22.625" from the bushing to the end of sheet metal. The end of this piece falls in the center of the trunion - directly under the top cover hinge pin.
- None of the slots or...
Includes front post and nut
Includes Rear Screw and Nut
Includes Front Post with Nut and Rear Screw with Nut
German MG3 ratchet plate for your MG42, MG1, MG3 or Yugo M53 build. Hard to find part in uncut condition.As pictured these are taken off German receivers. As such they are not new. These are rough as there is no easy way to remove one from a demilled...
New Production - copied exactly from an original part. Barrel sleeve not included (shown in top picture for reference only)
German production MG3 rails: no holes
New Production, sold as set of 2
New made items:
Includes Upper and Lower brackets for the barrel change door hinge and receiver mount.
Machined from steel.
To install, they must be welded to the inside channel of the barrel jacket in proper location for the barrel to lock...
WW2 production w/ markings. Includes latch and spring
Reproduction of spring for MG42 buffer latch
Includes only the Stud.
New Production MG-42 Front Anti-Aircraft Speed Ring Mount Copied exactly from an original piece. Includes retaining clip spring and rivets. Speed-ring not included.
PART IS NOT METAL FINISHED
New Production - sold as set of 2
MG42 Ratchet Plate (new production)
Includes rivets for:
rear trigger housing / tripod mount
trunion (trunion screw also included)
front tripod mount
rear sight bracket
front AA post ( AA post retainer spring also...
This part is welded to the underside of the MG42 Semi-Auto receiver to prevent the introduction of a full auto bolt.
Yugo M53 markings
Mixed WW2 and Yugo M53 Production with pin included
Original post-war German bakelite buttstock.
Overall good condition wiht some scuffs, chips and minor rust on metal hardware.
New Production. Includes upper and lower tabs, latch stud, and rivets
These buffer tabs are machined from 4140 steel.
Original PIAT bristle brush. Approximately 12" long with 1.5" diameter brush.
Also, very useful for cleaning the inside of MG34 & MG42 barrel jackets, and BREN receivers.
2 x 50 rd Basket Drums in canvas carrying bag
1 x MG42 Barrel Carrier
1 x Action Cover
Tool Kit in Canvas Roll that includes:
MG42/53 Extractor Removal Tool
Hot Barrel Mitt
Canvas Carrying Bag
Broken Shell Extractor...