MG42 Semi Auto Bolt Parts

MG42 Semi-Auto Bolt Rear Post Assembly

Includes Roller Bearing, Support Shim, Rear Post, and Screw     The Rear Post is pressed into the bearing hole in the original bolt carrier (002 interference fit). The original bolt carrier will...

MG42 Semi-Auto Firing Pin Support Bushing

This bushing gets pressed into the ejector pusher to support the semi auto firing pin

MG42 Semi-Auto Firing Pin (First Pattern)

MG42 Semi-Auto Firing Pin with Spring FIRING PIN SUPPORT BUSHING REQUIRED - SOLD SEPERATELY  These are designed for modified original MG42 bolt carriers with the rear roller post used as the stop...

MG42 Semi-Auto Mainspring - Made with Black Oxide Protective Finish

For BRP-pattern MG42 SA Black Oxide Rust Protection Finish  Ends: Closed & Ground  

MG42 Semi-Auto Bolt Blocker

This part is welded to the underside of the MG42 Semi-Auto receiver to prevent the introduction of a full auto bolt.

MG42 Ratchet Plate

MG42 Ratchet Plate (new production) 1010 CR steel Made from 2.5MM Thick Steel Per Original design Slot for charging handle not machined 4 x 4mm holes for posit

MG-42/53/3 Short Recoil/Recuperator Screw Set: Front Post, Rear Post and 2 nuts (new production)

New production Includes Front Post with Nut and Rear Screw with Nut

MG42/53 Ejector Bar - spoon - Yugo (original)

Original Item: Yugo

MG42-M53 Bolt Carrier - YUGO

Original Item  Yugo markings